1-14
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Unpacking Instructions
Note
If the shipping carton is damaged upon receipt, request that the
carrier’s agent be present during the unpacking and inspection of
the equipment.
Unpack the equipment from the shipping carton. Refer to the packing list
and verify that all items are present. Save the packing material for storing
and reshipping of equipment.
Caution
Avoid touching areas of integrated circuitry. Static discharge can damage
circuits.
Before Installing the CPV5370
After removing the CPV5370 from its packaging:
❏
Check for obvious physical damage.
❏
Verify that the coin cell battery is in its holder and inserted
correctly.
Make sure that you disconnect the chassis from the main power supply
before you continue.
Antistatic Precautions
Use ESD
Wrist Strap
Motorola strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system. Electronic
components, such as disk drives, computer boards, and memory modules,
can be extremely sensitive to electrostatic discharge (ESD). After
removing the component from its protective wrapper or from the system,
place the component flat on a grounded, static-free surface (and, in the case
of a board, component side up). Do not slide the component over any
surface.
Solution Systems Technologies Inc.
720-565-5995 | info@solusys.com | www.solusys.com
Solution Systems Technologies Inc.
720-565-5995 | info@solusys.com | www.solusys.com
