Manual FRAME-EVO-P20 / P20-US
Version 1.6
10.01.2019
Page
15
of
39
5. Fitting the projectors in the frame
Step 1:
Place the projector upside down on a suitable flat surface then remove the lens
(if it is pre-installed). For easier access you may first remove the upper ring before mounting
the projector. Please refer to chapter “
6. Removing the Upper Ring - Installation Version
Otherwise it is recommended to place an appropriate material underneath the projector so
that it is lifted up for about 10 cm. This will help during the following process.
Step 2:
Position the frame over the projector so that the adjustment screw is at the back,
aligning the M6 screw holes. Please put the projector in the right position so that the
front/back position is correct when installing. Otherweise the position of the holes will
not match.
Lens
