34
Press "Ok"; the letter “A” starts to flash. Using the “+” and “-” keys, select the desired
letter. Press "Ok" to confirm; the numbers “00” start to flash. Using the “+” and “-”
keys, select the desired number. Confirm by pressing "OK" to go to the “Configurações
Gerais” ("General Settings") menu.
ON
OFF
OF
F
+
OK
OFF
MENU
OFF
MODE
OFF
ESC
OFF
-
MAN
AUT
OFF
esc
A
00
Ok
<
Password
>
Note: The password is only provided to authorised technicians.
10.
Start-up
After loading the pellets into the deposit, press and hold the ON/OFF button for 3s, to
start the Free Standing Fire. During the lighting phase, the display will show the
message “Ativação” (Activation) until this phase is completed.
The pellets are fed through the supply channel to the burning basket (combustion
chamber), where they will be ignited using a heat resistor. This process may take 5 to
10 minutes, depending on whether the worm screw used to push through the pellets
has been previously filled with fuel or is empty. Once the ignition phase is completed,
the message "On" appears on the display. The heating power can be adjusted at any
time by pressing the power selection button for approximately 1 second. You can select
from the five pre-set power levels that are available. The selected power is indicated on
the display. The initial power status at each start-up will correspond to the power level
set before the last stop.
Important notice: Before starting up the unit, please check to determine if the
deflector plate is in place.
10.1 Stop
The stop sequence of the unit is started by pressing the ON/OFF button for 3 sec.
The display will show “Desativação” (Disabling) until full completion of this phase.
The extractor will operate until the fume temperature of 64ºC is reached,
to guarantee
that all the material has been burnt.
Summary of Contents for Douro 12kW
