14
The use of different pellets reduces the efficiency of the pellet stove and leads to
deficient combustion processes.
As a recommendation always opt for certified pellets not forgetting that
before buying large quantities you should always test a sample.
The physico-chemical properties of pellets (in particular size, friction, density and
chemical composition) may vary within certain tolerances and according to the
manufacturer. This can cause changes in the feeding process and consequently
different dosages (with more or less pellets).
In this way it may be necessary to adjust the quantity of pellets according to their
quality even if these are certified.
The stove allows the pellet dose to be adjusted to ± 25% during the start-up
phase and at the power levels (see point 8.3.5 of the manual).
The appliance may NOT be used as an incinerator.
7.
Use of pellet stove
Recommendations
The following points must be checked before starting up the appliance:
- Make sure that the stove is correctly connected to the power supply via the 230VAC
power cable.
Figure 8 –Power connection plug
- Check whether the pellet tank is full. Inside the pellet tank there is a safety grid to
prevent the user from accessing the worm screw.
The combustion chamber of the stove and the door are built of iron sheet
painted with high temperature paint, releasing fumes in the first burns due to
the cure of the paint. Avoid touching the equipment during the first firing so
as not to leave permanent marks on the paint because it goes through a more
plastic phase during its curing process. The curing of the paint occurs at
approximately 300ºC during 30 minutes.
Summary of Contents for K50
