8
Front Back Side Top
Figure 2 – Dimensions of the K50 pellet stove (e.g. Europe model)
5.
Installation of the pellet stove
Before starting the installation, perform the following actions:
- Check immediately upon receipt that the delivered product is complete and in good
condition. Any defects must be indicated before installing the appliance.
- The base of the salamander has four height-adjustable feet, allowing simple
adjustment on uneven floors.
Figure 3 – Adjustable feet
Remove the Access Brochure from the online instruction manual and hand deliver it
to the customer;
Connect an 80 mm diameter duct between the flue gas outlet hole and a smoke
exhaust duct to the outside of the building (e.g. chimney) - see diagrams in points 5.1
to 4.3.
If a pipe is used for the combustion air inlet from the outside, it must not be more
than 60 cm in length horizontally or contain disturbances (e.g. bends);
Connect the 230VAC power cable to a grounded electrical outlet.
The side of the appliance containing the hot air outlet must face the space to be
heated.
Summary of Contents for K50
