45
a)
b)
d)
e)
Figure 24 – Connecting the sensors to the circuit board
2 – Next, you should remove the storage unit’s level sensor. By default,
it comes installed on the left side of the storage unit (the storage unit is
set up by default to be installed on the right side of the boiler). To do this,
loosen the screws of the part that supports the sensor and remove the
set.
Figure 25 – Removing the storage unit’s level sensor
3 – With the sensors already connected to the circuit board, you must
connect the boiler to the mains.
Summary of Contents for SZM A 18 KW
