81
User interface
The user interface was designed with a single button, a red/green LED and
four yellow LEDs
Figure 71 – User interface
When the pump is operating, the LED 1 is green. 4 yellow LEDs indicate
the current performance of the pump, as shown in the following table
(Figure - 72).
LED activo
Performance (%)
LED Green
0 (Standby)
LED Green + 1 LED yellow
0 - 25
LED Green + 2 LED yellow
25 - 50
LED Green + 3 LED yellow
50 - 75
LED Green + 4 LED yellow
75 - 100
Table 4
–
P
erformance of the pump
Figure 72 – P
erformance of the pump
Note: the pump is configured as standard at full capacity (75-100%).
Changing the setting of the pump
Can be chosen between the the view of the performance of pump and th view of
settings, just press the button once.
If you need to change the pump performance, you must press the button for 2
seconds (see Figure - 73), after this action the LEDs start blinking, then you must
press the button until the desired setting (see Table 5), after 10 seconds the
display automatically switches to the view of performance with alteration saved.
Summary of Contents for SZM A 18 KW
