Start & Stop Push Button Station
To operate the pulper:
1.
Ensure the drain valve is closed.
2.
Ensure that the pulper and extractor
lids are closed
3.
Ensure the “Empty/Run” selector switch
is in the “Run Position”
4.
Flip the locking lever to release the
red stop button. The pulper will pre-
fill with water.
5.
When the pulper is pre-filled, the
green button will illuminate.
6.
Press the green button to start the
Pulper.
The Pushbutton Station may be located under the
table, on the wall or if specified may be
installed into the control panel door.
