22
•
Memorising the remote controls:
ON/OFF
AUTO
PROG
On each remote control, the first button memorized will control leaf opening completely.
Place the remote control against the target engraved on the hood and do the following
operations :
2
Parametering your PASSEO/AXOVIA
2
At the end of the memorization cycle, only the PROG and ON/OFF lights are lit, the
electronics waiting for memorization of leaf displacement
•
Memorisation of leaf displacement :
The Somfy electronics automatically memorizes :
• The force of the cylinders necessary for gate control in normal operation. This
memorization then makes it possible to detect any abnormal force on the motorization.
• The angles necessary for complete opening and closing of the gate leaves with
locating the stops. This memorization then makes it possible to slow down before
reaching on the stops.
In order to start up the memorization process with the LEAF CLOSED, stand at a normal distance from
the gate and respect the following steps :
• Push on the programmed button
designed for complete opening.
1
>After a few seconds, the gate
opens at low speed.
• Once the gate is open, push again on
the same button.
2
>The gate closes, one leaf after the
other.
STOP
STOP
• Push on the second button.
>Only the covering leaf should open. A
new push on this same button
controls closing the leaf.
STOP
Your gate is now ready to operate. Push on the remote control button, your
gate opens automatically. Push again and it closes behind you.
Parametering your PASSEO/AXOVIA
At the end of these 4 steps, the PROG light turns off, indicating the end of the gate
displacement memorization procedure.
This cycle must be complete (2 complete, uninterrupted openings/closings). If it is
interrupted, the process is simply postponed and will be taken up again at the next
controlled opening.
Push again on the same
button.
3
>The gate opens, still at low
speed.
STOP
• Push a last time.
4
>Both leaves close almost
simultaneously.
STOP
2
Maintain the button to be memorized
pressed until the PROG light blinks slowly
(the DANGER
light lights up during this
operation)
1
• Check the pedestrian mode (leaf covering M1) :
E
n
g
li
s
h
Repeat these operations for :
• the second button (pedestrian
opening),
• the other remote controls to be
memorized.
Release the button : it is
memorized.
