EOLIS
Inteo Wind Control
Installation and Operating Instructions
DESCRIPTION
INSTALLATION PROCEDURES
1.
2.
3.
4.
The Eolis should be mounted as close to the motor as possible. If
mounted outside, ensure that the connections are facing down to avoid
rain seepage. Avoid mounting the control against any metallic surface,
as this may affect the radio reception.
Connect high and low voltage wires according to the wiring diagram
on the next page.
Make sure to use included
watertight strain relief fittings to maintain the weatherproofing of the
enclosure.
The wind sensor should be placed close to the awning or shading
system to make sure the wind speed is measured at the product.
Guard against installing the wind sensor too close to an obstruction
such as a chimney, gutter or the window treatment itself, which could
block the wind and cause erroneous sensor readings. The sensor
should not be more than 100 feet from the control.
The low voltage switch should be located no more than 100 feet from
the Eolis Control.
It is recommended that the low voltage wiring is
done first, for easier access to the terminals.
Remove the back
cover of the sensor and connect the two-wire cable (included) from the
terminals on the sensor to the terminals on the control. Refer to the
diagram on the next page.
The new Somfy Eolis is a single motor control designed for residential
use. It includes a wind sensor and a low voltage switch. Wind speed is
continuously monitored, triggering the control to retract awnings or
lower shutters automatically as needed.
This new control is packaged in a
weatherproof enclosure and includes watertight strain-relief fittings for
wires entering the box.
Two user-defined intermediate
positions can be programmed.
Catalog No: 6301021
CAT. NO:
2500021
SOMFY SYSTEMS, INC.
47 Commerce Drive
Cranbury, NJ 08512
SOMFY CANADA
6315 Shawson Drive, Unit #1
Mississauga, Ontario L5T1J2
SOMFY MEXICO S.A. De C.V.
Calle 3 No.47, Loc.E-5
Fracc Ind. Alce Blanco
Nau.,Edo. de Mex C.P. 53370,Mex
SOMFY SYSTEMS, INC. 1/01
C
SOMFY SYSTEMS, INC. reserves the right to change,
update or improve this document without prior notice.
