8
EN
EN
- Replacing the EXAVIA 500 / WISPA 800 / SGS 201SGS 400 / SGS 501 electronic unit - SOMFY
•
Connect phase and neutral to terminals 16 and 17 (red
"230 V" label on the electronics)
•
Lock the 230 V power supply cable with the cable clamp
provided.
•
Fit a terminal block on the earth wire (yellow/green) and
store it in the control unit.
5.1 Switching the installation on
The indicator light flashes (twice).
The motor is switched on and awaiting auto-programming.
If the indicator light does not come on or the number of flashes is not as expected: see diagnostic page 16.
5.2 Memorising the remote controls
NT
NT
BUS
BUS
3
3
2
2
4
4
5
5
6
6
START
ART
M1
M1
M2
M2
11
11
13
13
10
10
12
12
BATT
BATT
+
+
-
-
LIGHT
LIGHT
230V
230V
15
15
17
17
14
14
16
16
7
7
-
FLASH
8
8
9
9
24V
+
L
L
N
N
Neutral
Live
230 V power supply cable
Cable clamp
5.3 Auto-programming the gate leaves’ travel
1.
Press button 1 on the remote control to initiate a COM-
PLETE opening motion of the gate. The leaves open one
aer the other.
2.
When the gate is completely open, press button
1 on the
remote control again to launch a
FULL closing movement
of the gate.
3.
Press button 1 on the remote control to initiate a COM-
PLETE opening motion of the gate. The leaves open with a
slight delay.
4.
When the gate is completely open, press button
1 on the
remote control again to launch a
FULL closing movement
of the gate.
When the gate is completely closed, the indicator light
on the control unit should be CONTINUOUSLY LIT.
Prerequisites:
•
Check that
the installation is switched on: indicator light
flashes (2 flashes).
•
The gate must be closed.
3
4
1
2
CONNECTING TO THE POWER SUPPLY
4
COMMISSIONING
5
For your safety, these operations must be carried out with the power supply switched off.
1
2
3
>2s
<0,5s
If indicator light is not lit, press button
on
the control electronics for 2 seconds.
The indicator light comes on.
Position the new remote control to be
programmed on the control electronics target.
Briefly press the button on the remote control
to be programmed. The RADIO indicator light
will come on then go out when you release the
button on the remote control.
Complete opening is programmed on this
button.
