9
EN
- Replacing the EXAVIA 500 / WISPA 800 / SGS 201SGS 400 / SGS 501 electronic unit - SOMFY
EN
If indicator light flashes, relaunch auto-programming of the leaf travel (4 full opening and closing movements).
If the indicator light continues flashing, consult the troubleshooting guide page 16.
If the gate re-opens at the end of the closing movement, loosen and offset the gate leaf brackets slightly towards the centre of
the gate.
Operating your gate in sequential mode and complete opening mode
Successive presses of the same remote control button will lead to the following movements of the gate:
Open, Stop, Close, Stop, Open etc.
5.7 Default operation
5.4 Checking the position of the antenna
ANT
ANT
BUS
BUS
1
1
3
3
2
2
4
4
5
5
6
6
START
ART
M1
M1
M2
M2
11
11
13
13
10
10
12
12
BATT
BATT
+
+
-
-
LIGHT
LIGHT
230V
230V
15
15
17
17
14
14
16
16
7
7
-
FLASH
8
8
9
9
24V
+
L
L
N
N
Antenna
5.5 Closing the control unit
5.6 Standby / reactivation of the control electronics
Once the self-programming process has been completed, the electronics automatically switch to standby aer 5 minutes of inactivity to save
energy.
In standby mode, all indicator lights are off.
To check if the motorisation is switched on or to check/modify the parameter setting, press the
button for 2 seconds to reactivate the
electronics. The electronics will pass automatically to stand-by aer 5 minutes of inactivity.
5.8 Detecting an obstacle
When closing the gate, if an obstacle is detected (abnormal force on the motorisation), the gate stops then reopens
When opening the gate, if an obstacle is detected (abnormal force on the motorisation), the gate stops.
The gate movements must not be interrupted (complete opening/closing).
If they are interrupted, programming will resume the next time the opening command is issued.
WARNING
Once installation is complete, it is essential to check that the obstacle detection complies with annex A of the standard EN 12 453.
For optimum performance, it is essential that the antenna is
correctly positioned.
Do not cut the antenna wire.
1
2
Affix summary label to the back of the control unit cover.
Close the control unit and screw in the cover.
