Copyright © 2014 Somfy SAS. All rights reserved.
ES
29
2. INSTALACIÓN
El profesional de la motorización y automatización de la vivienda encargado de la instalación del minimotor
Irismo debe seguir
obligatoriamente
las instrucciones descritas a continuación.
No golpee, perfore, sumerja ni deje caer nunca el motor.
Instale un punto de mando individual para cada motor.
¡Advertencia de seguridad!
Información
Atención
2.2. CABLEADO
(fig. C)
Si los cables deben atravesar una pared metálica, deben protegerse y aislarse con un manguito o una vaina.
Fije los cables para evitar cualquier contacto con un componente en movimiento.
Deje accesible el cable de alimentación del motor: debe poder ser sustituido fácilmente.
-
Conecte la toma de alimentación al motor (utilice únicamente el suministro eléctrico Somfy con este motor).
-
Enchufe el conector del cable de alimentación al otro extremo del suministro eléctrico y conecte la clavija a la toma mural.
Cableado DCT
(fig. D)
Controles compatibles: cableado de control
(fig. E)
1) Herramienta de ajuste
2) Centralis IB
3) Interruptor de 2 contactos secos normalmente abiertos
2.3. PUESTA EN MARCHA
2.3.1. Registro previo del punto de mando RTS (solo para la versión RTS) (fig. F)
1) Conecte el enchufe CC de suministro eléctrico al motor y la toma de alimentación a la toma principal.
2) Pulse simultáneamente los botones
Abrir
y
Cerrar
en el punto de mando RTS: el producto automatizado efectuará un
movimiento de subida y bajada y el punto de mando RTS quedará registrado en el motor.
2.3.2. Ajuste de los finales de carrera
Con la primera orden Abrir o Cerrar, el producto automatizado realiza una primera marcha para registrar la posición del tope.
2.1. MONTAJE
2.1.1. Instalación del riel (fig. A)
1) Marque la posición de los soportes.
2) Practique los agujeros necesarios en el techo o
la pared.
3) Fije los soportes.
4) Fije el riel en los soportes.
2.1.2. Instalación del motor (fig. B)
1) Desbloquee el motor
2) Inserte el eje del motor en el agujero de la polea
conductora.
3) Bloquee el motor.
1
CCW (abierto) SIN contacto seco
4
+5 V
2
IR OUT
5
Parada. SIN contacto seco
3
Tierra, común
6
CW (cerrado) SIN contacto seco
Abrir
STOP/my
Cerrar
Herramienta de ajuste DCT
Punto de mando RTS
Véase la ilustración de la página 92.