SOMFY Irismo Plus, Instructions Manual

6

Copyright © 2018 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved

.

EN

2.3. COMMISSIONING

2.3.1. Pre-programming the RTS remote control (Fig 5)
1) Connect battery pack to the motor, refer to 2.2.1.
2) Press the 

Open and Close buttons on the RTS remote control at the same time: The motorised product 

moves briefly, and the RTS remote control is pre-programmed in the motor.

2.3.2. Setting the end limits 
At the first command Open or Close, the motorised product make a first run to record the hard stop position.
If need to adjust end limits, refer 2.4.2

2.3.3. Checking the direction of rotation (Fig6)
1) Press the 

Open button on the RTS remote control:

a) If the motorised product opens (a), the direction of rotation is correct.
b) If the motorised product closes (b), the direction of rotation is incorrect: Move onto the next step.

2) Press the 

my button on the RTS remote control until the motorised product moves: The direction of 

rotation has been modified.
3) Press the 

Open button on the RTS remote control to check the direction of rotation.

If need to change the direction of rotation, refer 3.4.4

2.3.4. Recording the RTS control point (Fig 7)
Press the PROG button on the back of the remote control until the motorised product moves. The remote 

control address is permanently recorded.

2.3.5. Adjusting the Touch motion sensitivity (Fig 8)

Move the motrised product away from the end limits.

1) Press the 

Open and Close buttons of the RTS remote control simultaneously until the motorised product 

moves.

LED is green the motor enter touch motion sensitivity setting mode

2) Press the 

Open and Close buttons simultaneously until the motorised product moves to switch from high 

sensitivity, to low sensitivity, to no touch motion, and back to high sensitivity.The LED is on

- orange LED fast blink for high sensitivity

- orange LED slow blink for low sensitivity

- orange LED on for no touch motion

3) Press the 

my button until the motorised product moves to confirm the setting.

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Irismo Plus WireFree?

Observations

Possible causes

Solutions

The motorised product 
does not operate.

The battery pack is weak.

Check whether the battery pack is 
weak and charge  it.

The remote control battery is weak.

Check whether the battery is weak and 
replace it if necessary.

The remote control is not 

compatible.

Check for compatibility and replace the 
remote control if necessary.

The remote control used has not been 
programmed into the motor.

Use a programmed remote control or 
program this remote control.

