106
CONTENTS
2. NINA TIMER IO REMOTE CONTROL 5
3. USING NINA TIMER IO
Copyright © 2017 - 2021 SOMFY ACTIVITÉS SA, Société Anonyme. All rights reserved.
Upgrading an installation already equipped with Nina Timer io
Reset to factory settings
Erases all settings made during the first installation: paired devices, groups, scenarios, alarm code, typical days,
weekly programming, etc.
Reset
button and restore factory settings with the
Sleep
button
If
necessary, there are two buttons on the right on the back of the remote control:
1. Remove the back case from the remote control to
access the buttons: the
Reset
button (A) is in the
middle, and the
Sleep
button (B) is at the bottom.
2. To restart the remote control if it is locked or the
screen is frozen: using a pen,
briefly
press the
Reset
button (A). None of the settings are lost.
3. To restore factory settings:
> USING a pointed item (e.g. a paper clip), press the
Sleep
button (B) for at least 2 s: the green LED will
flash four times and the remote control will go into
forced standby mode.
> Place the remote control on its base to exit forced
standby mode and
while it is restarting
(green
LED lit up), press the
Sleep
button (B) again for at
least 2 s: all of the settings made are deleted.
To restart the installation from the beginning, see
First installation of Nina Timer io, page 95
.
2
1
A
B
3
B
B
A
2
