4) Resetting the motor's memory (recording a new
transmitter when the original transmitter is lost.)
for 1 second
max.
(with a new transmitter after losing the 1st one)
**A.
Perform a power cut in the following sequence:
1. Power-off - 2 sec. minimum
2. Power-on - 5 to 15 seconds
3. Power-off - 2 sec. minimum
4. Power-on
The end product moves for 5 seconds in one direction,
to indicate that the double power cut has been recorded.
The motor is in a PROGRAMMING STATE for 2 minutes.
Proceed to STEP B or C depending on the desired result.
Press the programming button of the NEW RTS transmitter,
Release it after the end-product jogs briefly UP/DOWN
indicating that the transmitter has erased all previous transmitters
and recorded the NEW one.
Press and
the programming button for more than 7 seconds
of the NEW RTS transmitter. The end-product will jog briefly UP/DOWN
twice. Once after 1 second and again after 7 seconds. This indicates the
OREA RTS motor has been completely cleared.
B. RECORDING A NEW TRANSMITTER
C. RESTORING FACTORY MODE
(after losing the 1st transmitter)
HOLD
>5 sec.
NEW TRANSMITTER
5 seconds
WARNING:
This type of power cut affects all
the OREA RTS motors on the same power line. To
avoid resetting of non-concerned motors, press briefly
any button of their assigned transmitter. (UP, STOP, or
DOWN) The non-concerned motors will return to
USER MODE.
**RESETTING MOTORS BACK TO USER MODE
!
Release it after the end-product jogs briefly UP/DOWN
The memory of the receiver is cleared (all the previous
sensors are erased) and the new sensor is recorded.
Press for more than 7 SECONDS
on the programming button of the
new RTS
.
sensor
-
+
-
+
Release it after the end-product jogs briefly UP/DOWN
If it is a new sensor:
If the sensor was previously recorded:
it will be recorded into the motor.
it will be deleted.
Press BRIEFLY on the programming button
of the RTS
.
sensor
b) Record or delete a sensor
c) Erase all the sensors and record a new one
Transmitter
previously
recorded
-
+
-
+
>7 Seconds
!
Release it after the end-product jogs briefly UP/DOWN
indicating that the OREA RTS motor is in a
PROGRAMMING STATE.
Press the
(for more than
2 seconds) of the RTS transmitter/channel which
is already recorded in the motor.
programming button
3) Add or Delete an EOLIS or SOLIRIS Sensor RTS in the memory of OREA RTS motor
a) Enter the "PROGRAMMING STATE"
>2 Seconds
NOTE: A double power cut cannot be achieved if the motor is
still in FACTORY or INSTALLER mode. First program a
transmitter into the memory of the motor.
