SOMFY Smoove 1 RTS, Quick Start Manual

Operation for Smoove 4

A. Button (raise, switch on, open, tilt)
B. 

“my”

 button (stop, go to favorite position)

C. Button (lower, switch off, close, tilt)
D. Channel selection indicator 
E. Programming (PROG) button 

     (On backside of faceplate)

Pairing a Smoove 4 to a window covering and creating channels

• Press and hold the 

Programming (PROG)

 button on the window covering motor until the window 

    covering moves up and down. 

Note: You have 2 minutes to successfully complete RTS programming 

or it will default back to factory setting, and you will have to start process over again.

• Assign the window covering to a channel by selecting that channel (D) on the Smoove 4. 

• Press the 

Programming (PROG) 

button (E) on the Smoove 4.

• The window covering will move up and down, indicating a successful pairing. 

• Repeat this procedure, assigning window coverings to channels until you have paired all the 

    window coverings to the Smoove 4. 

• To remove a window covering from Smoove 4 control or to change its channel:

  1. 

Press 

Programming (PROG)

 on the mounted window covering motor.

2. Press the channel button (D) on the Smoove 4 to which the window covering is assigned.

3. Press the 

Programming (PROG)

 button (E). The window covering will move up and down, 

       indicating it is now removed from the Smoove 4 and its assigned channel. 

Daily Use

• On the Smoove 1, select a channel, then press the         (A) or       (C) to open or close the 

    window covering. 

• To stop the window covering at a specific position, press the “my” button (B). 

Creating Preset Positions

To create a preset position:

• Press the channel number (E).

• Adjust the window coverings to the desired position.

• Press the “my” button (B) until the window coverings move up and down. The preset is now activated.  

To delete a preset position 

• Press the channel number (E).

• Press the “my” button (B). The window coverings move to a preset position. 

• Press the “my” button (B) again until the window coverings move up and down. 

    The preset position has been deleted.

Daily Use of Preset Positions - The “my” button on the Smoove 4 opens and closes your window coverings 

to your preferred preset conditions. 

• Press the channel button (E).

• Press the “my” button (B).  

• The window covering will move to a preset position.

The Smoove 4 operates four different groups of window coverings. 

As you pair your Smoove 4 to each window covering controller, you also build each grouping. 

Continued On Next Page