Battery Replacement
1. Unclip the frame by using a small
flat head screwdriver to open (against
the small groove shown in image 1)
2. Remove old battery then insert a
new CR 2430 3 V battery, (+) side up.
3. Replace the frame and Module onto
the mounting frame by pressing
back to original position.
Troubleshooting
Observation
The window covering
does not move
Possible Causes
Weak battery
Window covering
not paired with device
Signal interference
from nearby electronics
Solution
Insert new battery
See section 3 Pairing a
Smoove
Turn off nearby electronics
Replacing a lost or broken Smoove 1 or 4 Controller
To Replace a lost or broken remote, follow these steps with the NEW transmitter.
1. Press and hold the Programming (PROG) button on the window covering motor until the window
covering moves up and down.
2. Press the Programming (PROG) button (E) on the back of the Smoove 1 until the window covering
begins to move up and down.
3. The Smoove 1 is now paired with the window covering motor.
4. Follow steps of the installed motor to set the upper and lower limits
AS WITH ANY PRODUCT INVOLVING
GENERATION OF ELECTRICAL POWER,
CAUTION MUST BE USED AT ALL TIMES.
PLEASE CAREFULLY READ AND FOLLOW
ALL OF THE INSTRUCTIONS.
This device is FCC certified and complies with part 15 of the FCC rules.
RTS compatibility: RTS transmitters are capable of operating any RTS motor.
Note: Visit https://store.somfysystems.com/ to
purchase an additional or replacement product.
