3
EN
Images not contractually binding
Copyright © 2016-2017 Somfy Activités SA, Société Anonyme. All rights reserved.
1.2 LIABILITY
Before installing and using the Sonesse 50 motorisation, please read
operating and installa-
tion guide carefully
. In addition to following the instructions given in this guide, the instructions
detailed in the attached
Safety instructions
document must also be observed.
The Sonesse 50 motorisation must be installed by a motorisation and home automation
professional, according to instructions from Somfy and the regulations applicable in the
country in which it is commissioned.
It is prohibited to use the Sonesse 50 motorisation outside the area of application described
above. Such use, and any failure to comply with the instructions given in this guide and in the
attached
Safety instructions
document, absolves Somfy of any liability and invalidates the
warranty.
The installer must inform its customers of the operating and maintenance conditions for the
Sonesse 50 motorisation and must provide them with the instructions for use and maintenance,
and the attached
Safety instructions
document, after installing the Sonesse 50 motorisation.
Any
After-Sales Service operation on the Sonesse 50 motorisation must be performed by a
motorisation and home automation professional.
If in doubt when installing the Sonesse 50 motorisation, or to obtain additional information,
contact a Somfy adviser or go to the website www.somfy.com.
2. INSTALLATION
Instructions which
must
be followed by the motorisation and home automation profes-
sional installing the Sonesse 50 motorisation.
Never drop, knock, drill or submerge the motorisation.
Install a separate control point for each motorisation.
2.1. INSTALLATION
2.1.1. Preparing the motorisation
1) Fit the accessories required to integrate the motorisation
in the roller tube:
• Either fit the drive wheel
a
on the motorisation.
• Or fit the crown
b
and the drive wheel
c
on the
motorisation.
2) Measure the length (L1) between the inner edge of the
motorisation head and the rim of the drive wheel.
2.1.2. Tube preparation
1) Cut the roller tube to the required length, depending on
the motorised product.
2) Deburr the roller tube and remove the swarf.
3) For roller tubes which are smooth inside, cut a notch
with the following measurements:
d
= 4 mm /0.16 In ;
e
= 28 mm /1.1 In.
1)
L1
L1 = …
2)
Ø > 47 mm
c
b
Ø = 47 mm
a
3)
1)
2)
d
e
Safety warning!
Information
Λ
Up
V
Down
Caution!
