4
EN
Images not contractually binding
Copyright © 2016-2017 Somfy Activités SA, Société Anonyme. All rights reserved.
2.1.3. Motorisation/tube assembly
1) Slide the motorisation into the roller tube.
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
2) The drive wheel must be locked in place to prevent it
moving along the roller tube:
•
This can be done either by fixing the roller tube to the
drive wheel using 4 x Ø 5 mm self-tapping screws,
or by using 4 x Ø 4.8 mm steel pop rivets placed 5
mm to 15 mm from the outer rim of the drive wheel,
regardless of the roller tube.
The screws or pop rivets must only be attached to
the drive wheel and not to the motorisation.
• Alternatively, a drive wheel stop can be used for tubes which are not smooth.
2.1.4. Installing the motorisation/tube assembly
1) Install and fix the motorisation/tube assembly onto the end
bracket
f
and onto the motorisation bracket
g
:
Ensure that the motorisation/tube assembly is secured
onto the end bracket. This operation prevents the
motorisation/tube assembly from coming out of the
end bracket mounting when the roller blind reaches
the lower end limit position.
2) Depending on the type of bracket, fit the stop ring
h
in
place.
15 mm
5 mm
20 mm
L1
1)
2)
1)
2)
h
g
a
b
Ø>47mm
e
h
e
h
f
a
b
Ø>47mm
e
h
e
h
2.2. WIRING
Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
Attach cables to prevent any contact with moving parts.
The cable on the Sonesse 50 can be removed. If it is damaged, replace it with an identical
cable.
Leave the motorisation power supply cable accessible: it must be possible to replace it
easily.
Always make a loop in the power supply cable to prevent water entering the motorisation!
-
Turn off the power supply.
-
Connect the motorisation according to the information in the table below:
Neutral
Live
Earth
230V -50 Hz
Blue
Brown
Yellow/
Green
220V -60 Hz
120V -60 Hz
White
Black
Green
3 x 0.75 mm
2
3 x 1,5 mm
2
1
2
3
