3. Attach 40mm crown and drive adaptors to motor.
4. Insert motor and adaptors into 40mm octagonal tube.
5. Fasten motor bracket to motor.
1. Cut 40mm octagonal tube to appropriate length for application.
7
* Take-up cords that are 6" from end of headrail (Max length of tube = headrail length - 4 / ")
8
2. Insert 40mm octagonal end cap into end of tube.
crown
drive
wheel
B. Motor and Tube Preparation
3
1
1. Cut the ladder braids to measure (7 / " For 2 Inch Horizontals) (6 / " For 1 Inch Horizontals)
4
2
2. Fasten ladder grip to create a loop (see illustration).
(Step 1)
(Step 2)
NOTE:
The ladder grip must be
under the upper slat
ladder
grip
X
C. Ladder Braid Assembly
3