1. With the take-up cord resting over the edge of the headrail, position the cone over the cradle bearing and slide ladder braid over
the cone and into the groove as shown below.
2. Press cone into headrail and position into cradle bearing.
3. Rotate each cone and align for
tube insertion.
2.. With the cones in proper alignment insert motor assembly into the headrail and cones.
1. Insert the idler end bracket into the headrail
and align with pre-drilled holes.
E. Cone Assembly
F. Motor and Tube Insertion
Take-up
Cord
Ladder Braid
Groove
2.. With the cones in proper alignment insert motor assembly into the headrail and cones.
5
