H. Final Adjustments
4. Fasten motor bracket and idler bracket to headrail using (#10 x 3/8" screws) or (5/32" x 3/8" poprivets)
1. Apply power and run the blind in the up or down direction. Adjust the travel distance with RTS remote (RTS
motors) or by turning the limit adjustment screws (non-RTS motors). See limit switch adjustment instructions
included with motor.
G. Securing Take-up Cords
4. Fasten motor bracket and idler bracket to headrail using (#10 x 3/8" screws) or (5/32" x 3/8" poprivets)
1. Temporarily hang the blind and extend slats to a
"lowered position." (be certain take-up cords remain accessible.)
2. With blind hanging in a "lowered position" carefully mark each
take-up cord with regard to each cone (see detail)
3. Tie a knot at the mark on each cord and fasten to each cone
respectively.
6
Marked Take-up Cord
Knot Tied at Mark
Detail of Knot Attached to Cone
1. Temporarily hang the blind and extend slats to a
"lowered position." (be certain take-up cords remain accessible.)
2. With blind hanging in a "lowered position" carefully mark each
take-up cord with regard to each cone (see detail)
3. Tie a knot at the mark on each cord and fasten to each cone
respectively.