7
Copyright © 2015 Somfy SAS. All rights reserved - V1 - 03/2015
2.3.3. Setting the end limits
The end limits can be set in any order.
1) Raise the motorised product to the desired
position by pressing the
up
button.
2) Press the
my
and
down
buttons at the
same time until the motorised product moves.
The upper end limit is memorised.
3) Press the
my
button when the motorised
product reaches the desired lowered position.
If necessary, adjust the position of the
motorised product using the
up
and
down
buttons.
4) Press the
my
and
up
buttons at the same
time until the motorised product moves.
The lower end limit is memorised. The
motorised product rises and stops in the
raised position.
5) To confirm the end limits, press the
my
button until the motorised product moves up
and down.
The end limits are programmed.
Do not set an end limit in a position able to raise the motorised product, as this
could damage the motorised product and/or the motor in the long term.
2.3.4. recording the rTS control point
The motorisation is in programming mode:
-- Quickly press the PROG button on the RTS
control point to be programmed:
→The motorised product moves up and
down: this RTS control point is programmed
in the motorisation.
if the motorisation is no longer in programming mode, repeat Step 2.3.1 then
perform Step 2.3.4.
1)
2)
3)
4)
5)
PROG.
Summary of Contents for Tilt 50 RTS
Page 1: ...Tilt 50 RTS Ref 5122959A EN Instructions FR Notice NL Manual ES Manual...
Page 2: ......
Page 43: ......
