OPERATION
Page 16
8.3
Operating procedure/Crushing cereals
Requirements:
The machine is connected to the power supply.
The machine is switched off
The inlet gate is fully closed.
There is no milling material on the pinch rollers.
Steps:
NOTE
Stationary pinch rollers!
There must be no milling material on or between the pinch rollers while the rollers are
stationary. Always close the feed gate first, and then fill the funnel with milling material.
1.
Fill the milling material into the hopper or silo feeder.
2.
Attach a catchment sack at the machine discharge or a catchment container below machine.
3.
Switch on the machine at the main switch.
Allow the pinch rollers to accelerate to final speed.
4.
Open the feed gate.
Grain runs onto the pinch rollers and is crushed.
NOTE
machine overload. Red zone on ammeter!
The red zone indicates a motor overload. Avoid permanent overload of the motor. It is not a
problem if the pointer briefly deflects into the red zone.
5.
Close the feed gate and allow the rollers to run empty.
6.
Switch off the machine at the main switch.
8.3.1
Adjust the feed regulator
Increasing and reducing the milling material feed:
1.
Push the wheel of the feed regulator towars the machine
