28. Due to continuous improvements, the technical data and design may change without any prior notice.
29. The actual instruction manual can be downloaded from www.somogyi.hu website.
30. We do not take the responsibility for printing errors which may occur, and apologize for them.
ASSEMBLY, INSTALLATION
1. Before installation, carefully remove packaging, and make sure not to damage the appliance or the power
cable. If you find any damage, the appliance must not be operated.
2. Stand the base of the appliance (11) on a horizontal surface and secure the stand’s lower piece (7) to it using
the base fixing screws (9).
3. Pull the plastic cover cone (8) and a cable clamp (12) on the stand’s lower piece.
4. Fit the middle piece of the stand (6) on it, and secure it with the matching screws (10). Attach a cable clamp
on the middle piece of the stand (12).
5. Fit the upper piece of the stand (5) on it, and secure it with the matching screws (10). Attach a cable clamp on
the upper piece of the stand (12).
6. Fit in and secure the product’s head piece on the upper part of the stand.
7. The heater’s stage switch should be set in „0” position.
8. Connect the appliance into a standard grounded wall outlet. Now the appliance is ready for operation.
Caution: Risk of electric shock!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged, imme
-
diately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufactu
-
rer, its service facility or similarly qualified personnel.
Do not cover! Covering the unit can cause overheating, fire or electric shock.
FEATURES
Halogen heater ● high heat radiation ratio ● IPX4 protection against splashing water ● 3 heating stages, max. 2000 W ● soundless
operation ● stainless steel stand ● switches off in case of tipping over
STRUCTURE (Figure 1.)
1. heater head piece
2. halogen heating elements
3. protective grid
4. stage switch
5. stainless steel stand upper piece
6. stainless steel stand middle piece
7. stainless steel stand lower piece
8. plastic cover cone
9. base fixing screws
10. stand fixing screws
11. base
12. cable clamp
13. power cable
OPERATION
The appliance can be operated with a stage switch, you can choose among the following options using it:
0. switched off state
1. first heating stage (650 W)
2. second heating stage (1350 W)
3. third heating stage (2000 W)
The height and the tilt angle of its head can also be adjusted. To set the height, loosen the height-set screw on the upper piece of the
stand, then after the desired height has adjusted, fasten it.
HEATING ELEMENT REPLACEMENT
Warning! The heating element may only be replaced by the manufacturer’s service facility.
The appliance may not be operated
without the protective grid in place.
The heating element operates much like a conventional incandescent light bulb. Burnt out heating elements are not covered by the
warranty as they are subject to natural wear.
