6.
Screw on the rear part of the grid (6) to the motor with 4 screws, so as to get the carrying handle (7)
on the top.
7.
Insert the fan blade (3) to the end of the axle (8) and fasten it with screw (4).
8.
Put the front part of the grid together with the rear part and fasten in with the clamps (
2
).
FEATURES
metal desk fan
•
30 cm blade diameter
•
adjustable output (3 stages)
•
fixed standing or oscillation (85°)
•
controllable dip angle of head
•
dense grid
Figure 1.
1.
front part of grid
•
2.
grill fixing clamps
•
3.
fan blade
•
4.
blade fixing screw
•
5.
screws for fixing rear part of grid
•
6.
rear part of grid
•
7.
carrying
handle
•
8.
motor axle
•
9.
speed level switch
•
10.
switch of oscillation
•
11.
motor
•
12.
circular base
•
13.
head dip angle fixing screw
•
14.
head dip
angle limiter screw
•
15.
head dip angle limiter groove
•
16.
ventilator fastening nut
•
17.
ventilator fastening screw
OPERATING FAN
With speed level switch (9) you can select 1st, 2nd or 3rd speed level, and the fan will switch off in position of O. Oscillation can be turned on by
pressing oscillation switch (10) down, and can be turned off by pulling it up.
Dip angle of fan head part can be adjusted from the horizontal position with +/- 15° up or down. To do this, loosen the screw (13), set the desired dip
angle, and then fasten the screw.
CLEANING
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the manner of use and degree of
contamination.
1.
Prior to cleaning switch off and power off the unit by unplugging it from the electric outlet!
2.
Attention! Remove the front part of grid when the fan is not under power!
3.
Use a slightly moistened cloth to clean the unit's exterior. Do not use any aggressive cleaners. Avoid getting water inside of and on the electric
components of the appliance!
4.
Attention! Put back and fasten the protective grid to the fan, when it is not under power!
5.
Only reinstall the fan afterwards!
TROUBLESHOOTING
Waste equipment must not be collected separately or disposed of with household waste because it may contain components hazardous
to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which
sells equipment of identical nature and function. Dispose of product at a facility specializing in the collection of electronic waste. By doing
so, you will protect the environment as well as the health of others and yourself. If you have any questions, contact the local waste
management organization. We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and
shall bear any associated costs arising.
TECHNICAL SPECIFICATION
power supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230 V ~ / 50 Hz / 35 W
protection class: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I.
maximum fan - air mass volume:. . . . . . . . . . . . . . . . . F = 44,95 m3/min
fan input power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P = 28,98 W
service value: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SV = 1,55 (m3/min)/W
power consumption in standby position: . . . . . . . . . . . P = 0,0 W
SB
noise level: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . L = 57,8 dB(A)
WA
maximum air speed: . . . . . . . . . . . . . . . . . . . . . . . . . . c = 3,03 m/sec
service value standard:. . . . . . . . . . . . . . . . . . . . . . . . IEC 60879:1986 (corr. 1992)
length of power cable:. . . . . . . . . . . . . . . . . . . . . . . . . 1,8 m
blade diameter: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 cm
ventilator height:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 cm
ventilator weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2,8 kg
Malfunction
Possible solution
The fan doesn't turn on.
Check the power supply.
Check the switches.
The fan does not oscillate.
Check the switch of oscillation.
Summary of Contents for home TFS30
Page 19: ......