Somogyi VB 6000 Instruction Manual Download

Page: 7 / 60

WarninGs

• Before starting to use the player, read these instructions carefully, then keep them in an accessible place for future reference.

• Seek professional assistance if necessary to prevent damaging the unit or motor vehicle.

• Do not attempt to remove the front panel when the unit is operating.

• Depending on the compressed files, the MP3 compression program used, and the quality of the USB/SD memory, anomalies may occur during playback which are not due to the unit malfunctioning.

• The playback of copy protected DRM files is not guaranteed.

• It is also possible to connect MP3/MP4 players using a USB cable but avoid connecting external hard drives this way.

• Do not store any additional files on the USB/SD device other than playable MP3 files because they can slow down or prevent playback.

• Do not connect phones, navigation devices or other equipment to the USB port for purposes of recharging.

• Do not store data media in the vehicle if it is exposed to freezing or extremely high temperatures.

• While underway, do not do anything that distracts your attention from driving. Manipulating the player while driving can result in accidents. If needed, stop the car while manipulating the player.

• Spend as little time as possible watching the display. Doing so can distract your attention from the road, and result in accidents.

• Do not listen to the player too loud. Set a volume that allows you hear external sounds while driving. Extreme volumes can also cause permanent damage to your ears.

• Do not disassemble or tamper with the player, as that can cause fire, accidents, or electric shock. Incorrect use or installation renders the warranty void.

• Only for use in cars with a 12 V battery and a negative ground. Using the player for any other purpose can result in electric shock, damage, or fire. The player was designed exclusively for use in vehicles.

• Always use melting fuses with the proper values. When replacing a fuse, make sure that the new fuse has the same nominal value as the one you are replacing. Using a different fuse can cause fire or damage.

• Do not block the player’s cooling vents, as that can cause its circuits to overheat, resulting in fire. Install the player properly to ensure adequate ventilation. The air vents around the edge must be left free.

• Make sure to connect the player correctly. Incorrect connections can result in fire or other damage.

• Prior to wiring/installation, be sure to remove the car battery’s negative terminal connection. This will prevent any electric shock or malfunction.

• Before connecting/installing the player disconnect the negative pole of the car’s battery. Doing so helps you prevent electric shock or short circuits.

• While installing the player never cut through cables or damage their insulation. Doing so can result in short circuit and fire.

• Before drilling holes or inserting screws into your vehicle’s body make sure you do not damage tubes or electric wires on the other side of the cover.

• Do not connect to any electric systems of your vehicle that operate steering, brakes, or any other safety function. Doing so can result in loss of control over the vehicle, and can cause fire.

• Do not install the player or its accessories in a location where they can prevent you from controlling the vehicle safely, e.g., between the steering wheel and the gear shift.

• Make sure that wires do not coil around neighboring objects. Arrange cables and wires in a way that does not hinder you in driving. Wires that interfere with your movement or hang over the gear shift, the brake etc.

can be extremely dangerous. (E.g., the connection cable of a media player connected to the USB port.)

• In case of any malfunction, turn of the player immediately, and consult your distributor. Many malfunctions are very easy to spot (e.g., no sound, bad smell, smoke, an external object inside the product etc.).

• Make sure that no external objects get into the USB socket or the memory card slot, as these can cause fatal damage.

• Protect it from dust, damp, liquids, heat, moisture, frost and impact, as well as direct heat or sunlight!

• When leading the connection cables make sure that their insulation does not get damaged by any sharp metal objects nearby.

• Do not connect any cables when the device is working. Never turn on the system with the volume at the maximum level. The pop or other noise spike which can be heard when switching on can cause irreparable

damage to the speakers immediately.

• The warranty is not applicable to damage caused by irresponsible or improper installation or use.

PreCautions

CleaninG

Use a soft, dry cloth and a brush for regular cleaning. To remove stronger stains, wet the cloth slightly with water. Avoid scratching the display’s surface; never wipe the display when it is dry, and do not use a coarse

cloth to clean the display. Do not use detergents. Make sure no liquid gets inside the product or onto the connectors.

teMPerature

Before turning on the player make sure that the temperature inside the car is between -10°C and +50°C, as the product is only guaranteed to operate properly within this temperature range. Extreme weather condi-

tions can damage the product.

findinG the riGht loCation and installation

When installing the product, make sure it will not be exposed to any of the following:

- direct sunlight or heat (e.g. from the heating system)

- wetness, high humidity

- a significant amount of dust
- strong vibration

in radio mode

in music playback mode

Power on and off

Mode

Mode select (RADIO / SD / USB / AUX IN)

Mute