OvErvIEw
rear
1. power
Connect to AC outlet 115–230V.
2. Wireless – line in Wired switch
Determines in which mode the speaker should
operate.
3. Wired volume setting
Set to desired level. NOTe: Only for wired audio
input.
4. line out
Connect to “Line in” on other System 9 speaker
with balanced cable.
5. line in
Connect from “Line Out” on CgV or other
System 9 speaker with balanced cable.
(make sure to switch to Line In Wired audio
input, see point 2.)
6. Volume Zone
Determines to which volume zone the speaker
should be set (A–F).
7. Channel
Set to channel 1, 2 or 3. (Whole system must use
same channel as CTX transmitter.)
8. id code
On each Channel(1-2-3), there are 10 different
ID codes. Set whole system with same ID code.
FroNT
9. led wireless indicator
Blue LeD indicates that the speaker is receiving
signal (wired or wireless). If there is no signal the
speaker automatically goes into standby after 5
minutes and the LeD changes from Blue to Red.
NOTe:
- Point 3–5 is only valid if the speaker is in wired
mode.
- Point 6–8 is only valid if the speaker is in wire-
less mode.
dusT CoVer
1
2
3
4
5
6
7
8
9
!
Click!
