OvErvIEw
rear
1. power
Connect to aC outlet 115–230V.
2. Wireless – line in Wired switch
Determines in which mode the speaker
should operate.
3. Crossover and level controls
Set crossover frequency 50 Hz–90 Hz,
and level -20 dB to +20 dB.
4. line out
Connect to “Line in” on other System 9 speaker
with balanced cable.
5. line in
Connect from “Line Out” on CgV or other
System 9 speaker with balanced cable.
(Make sure to switch to Line In Wired audio input,
see point 2.)
6. Volume Zone
Determines to which volume zone the speaker
should be set (a–F).
7. Channel
Set to channel 1, 2 or 3. (Whole system must
use same channel as CTX transmitter.)
8. id code
On each Channel(1-2-3), there are 10 different
ID codes. Set whole system with same ID code.
9. main power switch
FroNt
10. led wireless indicator
Blue LeD indicates that the speaker is receiving
signal (wired or wireless). If there is no signal the
speaker automatically goes into standby after 5
minutes and the LeD changes from Blue to Red.
11. ir eye for remote control
12. remote
adjust bass levels -20dB to +20dB.
If manual volume knob on rear is used, this
overrides previous adjustments done by remote.
nOTe:
- Point 4–5 is only valid if the speaker is in wired mode.
- Point 6–8 is only valid if the speaker is in wireless
mode.
2
3
1
4
5
6
7
8
9
10
11
BASS LEVEL
12