ZT09 Long Life Tracker User Manual
Web: www.sonaltrack.com
Email: sales@sonaltrack.com
Ph: 8613857402537
2
CARSET,A,B,C,D#
A: Sharp turn angle: Degree
B: Average turn speed: KM
C: Rapid acceleration increment: KM
D: Rapid deceleration reduction: KM, default:
75,20,8,18
When GPSGSE, 0 #, the following settings about G-sensor are valid
1
GSENACC,A#
Used to set the sensitivity of device acceleration
events (A = 1-6, Default: 5)
The following values indicate that the acceleration
event will be detected from 0 to 100Km/h in X time
range (unit: S).
A = 1, X = 58; A = 2, X = 29; A = 3, X = 19; A = 4, X =
14; A = 5, X = 11; A = 6, X = 9
2
GSENDIR,D#
Used to set the coordinate system of the device (D =
0-15),
The default is D = 5: the GPS antenna is facing the
sky, and the cable is facing the rear of the car.
D = 7: GPS antenna is facing the sky, wire is facing
the front
D = 4; GPS antenna is facing the sky, wire is facing to
the left
D = 6; GPS antenna is facing the sky, wire is facing to
the right
3
GSENCAL,D#
Used to calibrate equipment
When D = 1, the device will calibrate immediately after
receiving this command.
When D = 0, the device will be calibrated next time
after receiving this command.
Note:
It is recommended to adjust the coordinate system
under re-calibration
