Figure 1: Subwoofer Placement
In-Ground Subwoofers
Introduction
Thank you for purchasing a SLS Subwoofer. When properly
installed, this subwoofer will provide you with years of outdoor
entertainment pleasure. To get the most out of your new subwoofer,
please read this manual thoroughly before you begin installation.
The SLS system is designed to deliver a seamless, evenly
dispersed sound field in an ‘open air’ environment. An array of
multiple Satellite speakers and Subwoofers should be strategically
placed to minimize ‘hot spots’ and ‘nulls’ as you move around the
outdoor entertainment area.
Figure 1 shows the SLS placed along the perimeter of the
entertainment area. See Figure 1.
Select a central location for the subwoofer if using only one
(see Figure 1). If using multiple subwoofers, select locations that
are the same distance from the main listening area. Sonance
recommends one SLS subwoofer installed after every 4-5 satellites
in a chain.
Sonamp DSP 2-750 Amplifier Power Planning
The maximum number of satellites and subwoofers that can be
used in a system will depend on the amplifier power. It is important
to calculate the amplifier power your installation will require before
you begin. Multiple amplifiers may be required in large installations.
Refer to the SLS wattage calculator on the Sonance website:
www.sonance.com/outdoor/new-sls/subwoofers.
Adjustable Tap
This Sonance Landscape Series product features a wide bandwidth
Sonance Laminated Core Transformer (SLCT) with an adjustable
tap, allowing the system to be configured for 70V/100V or 8 ohm.
If using this SLS product in an 8 ohm application, ensure the tap
switch is positioned to the 8 ohm setting. If using this product in
a 70V/100V system, ensure the tap is positioned to one of the
70V/100V settings.
Subwoofer
1
Box Contents
(1) In-Ground Subwoofer
(2) Silicone filled wire nuts
NOTE: SUBWOOFERS ARE VERY HEAVY, ALWAYS TEAM LIFT.
LS12T SUB
LS15T SUB
Subwoofer Placement
AS A GENERAL GUIDELINE, (1) SUBWOOFER WILL COVER ABOUT 2000
SQUARE FEET OF LISTENING AREA
NOTE: ENSURE THAT ALL SATELLITES AND SUBWOOFERS ARE SET TO
EITHER 70V/100V OR 8 OHM TAP SETTINGS TO AVOID ANY DAMAGE TO
YOUR AMPLIFIER. DO NOT COMBINE PRODUCTS SET TO ANY OF THE
70V/100V SETTINGS WITH PRODUCTS SET TO THE 8 OHM SETTING ON A
SINGLE AMPLIFIER.
NOTE: THIS PRODUCT SHIPS WITH THE SLCT ADJUSTABLE TAP SET TO
300W. ADJUSTMENTS CAN BE MADE TO THE TAP SWITCH ONCE ALL
THE SATELLITES AND SUBWOOFERS ARE CONNECTED TO ACHIEVE THE
APPROPRIATE OUTPUT LEVEL.
Some 70V/100V system designs will require variations of higher
and lower output in different areas of the landscaping. The SLCT
adjustable tap allows each satellite or subwoofer to be individually
dialed to the desired output. Adjusting the tap settings will impact
your wattage calculations. Please review the Wattage Calculator on
the Sonance website: www.sonance.com/outdoor/new-sls
/subwoofers for more information.
