CMM-40
– USER MANUAL
62
6.7 Data record function
In order to realise data store it is necessary to do the following:
In the current testing mode, press
STORE
button one time,
enter into STORE function. On the left upper corner of LCD
shows
NO. XXXX
,
which states current storage serial number,
Then, press button
PEAK HOLD
to change into the initial
serial number 0000. (Press again it will change back). On the
right upper corner of LCD shows
XXXX
, which states how
many current storage is used,
Press
STORE
button again, enter into recording interval time
set up function. On the left upper shows 0000 S, which states
recording interval time; using button + and - to select, the
range is 0~255 seconds,
When the recording interval time is 0000 S, then press
STORE
button again to change into manual recording. Press the
STORE
button again to record once,
When the recording interval time is 1~255 S, then press
STORE
button again to start recording automatically from
0000 or XXXX (chosen earlier). Recording times is showed on
the left upper corner, data is showed on the right upper corner
(Due to digitally limitation, there is only display preceding four
numbers),
To finish above STORE function, press
EXIT
button shortly.
6.8 Data memory clean function
If you want to clean all the memory data, the steps are:
When power off, press the
EXIT
button long time,
Then turn the switch from
OFF
to random, and release the
EXIT
button, the LCD will flash thrice and meantime buzzer
thrice, which means all memory data have been cleaned.
6.9 Data recall function
In order to realise data recall it is necessary to do the following:
Press
STORE ( RECALL)
button two seconds to enter into
RECALL function. On the left upper corner shows XXXX,
which states current storage serial number. On the right upper
Summary of Contents for CMM-40
