16
8.2
Recalling Data
To recall stored data after the unit shuts off, press the MODE
button until LOG appears in the lower left corner. A LOG location
number will be shown below LOG, and the stored temperature for
that location will be display. To move to another LOG location,
press the UP and DOWN keys.
8.3
Log Clear Function
The “Log clear” function allows you to quickly clear all logged
data points. This function can only be used when the unit is in LOG
mode. It can be used when the user has any number of LOG
locations stored.
You should only use the LOG clear function if you want to clear
all the Log location data that is stored in unit’s memory. The “LOG
clear” function works as follows:
(1) While in LOG mode, press the Trigger, and then press the
DOWN button until you reach LOG location “0”.
Note: This can only be done when the Trigger is pulled. LOG
location “0” cannot be accessed, by using the UP button.
(2) When LOG location “0” shows in the display, press the
Laser/Backlight button. A tones will sound, and the LOG location
will automatically change to “1”, signifying that all data locations
have been cleared.
9 Battery Replacement
①
As battery power is not sufficient,
LCD will display “ ” replacement
with one new 9V battery is
required.
