KT-160 USER MANUAL
88
descriptions) therefore, if the user select "PAL" or "NTSC" an additional warning is
displayed:
After the selection is confirmed the camera switches its image to an external display
("PAL" or "NTSC") or to the camera screen ("LCD"). Select "No" to return to the selection
screen, pressing the trigger button (10) exits the menu without saving changes.
After the selection and approval, the camera remains in selected mode "PAL/LCD/NTSC",
and the user may exit it by pressing the trigger button. Until then, if the user selects an
external monitor, and there are problems with displaying the image, pressing button
,
and then
the user may return to displaying the image on the camera screen.
NOTE: It is recommended to switch the camera off before connecting / disconnecting an
external display.
3.9.7
Setting the alarm threshold and selecting the temperature tag type
Select the "Alarm. Temp" option from the "Set" menu and choose the sound alarm for high
temperature (when the specified value is exceed) or low temperature (when temperature
falls below the specified value):
After selecting "Low Temp." or "High Temp.", use "+" or "-" buttons to set the desired
value and press OK to confirm.
NOTES:
- Depending on the selected alarm type, the moving cursor on the screen will mark the
point of the highest or lowest temperature value (see section 2.2)
- The default setting is the high alarm for 100°C, and the moving cursor indicates the point
of the highest temperature.
