KT-
560 ● KT-650 ● KT-670 – USER MANUAL
45
13 Power supply and battery charging
The camera is powered by Lithium-ion buttery. It can also be powered from the mains through the
AC adapter.
The battery can be charged while being inside of the camera. The device is also supplied with a
spare battery.
Connect the AC adapter to the [17] socket to start charging procedure.
Charging can be performed only when the camera is not being used.
During camera operation, current power supply source indicator is displayed in the upper left corner
of the screen.
- battery power supply
- mains power supply
13.1 Using AC adapter
The LED light, which is located on the on/off button [12], indicates when the AC adapter is connected.
When the camera is turned on, the indicator shows battery charging status, flashing red while charg-
ing and lit green when fully charged.
13.2 Battery power supply
During camera operation the battery charge level is being shown in real time.
13.3 Charging batteries
When the camera is turned off, connecting the AC adapter and starting the charging procedure is
signaled by the LED charging indicator, embedded in the camera on/off button [12]
– flashing red
while charging and lit green when fully charged. When the battery is not being charged the indication
is turned off.
Li-Ion battery does not require performing full charge-discharge cycles during exploitation, however
it
is advised to perform 3 full charge-discharge cycles when using it for the first time
, and to per-
form one full charge cycle at least once in a several charge-discharge cycles.
The camera comes along with 2 batteries, which are advised to be used alternately. When using the
second battery, the first one should be charged.
NOTE!
Use only the battery, AC adapter and the external battery charger supplied with the
camera.
Do not remove the battery from the camera while it’s being charged.
Battery charging should be performed in 0...40°C ambient temperature range.
In order to maintain the proper parameters of the batteries, charging of unused batter-
ies should be repeated every 3 months.
Summary of Contents for KT-560
Page 1: ...USER MANUAL THERMAL IMAGER KT 560 KT 650 KT 670...
Page 2: ......
Page 58: ...KT 560 KT 650 KT 670 USER MANUAL 56 NOTES...
Page 59: ......
