KT-560M
– USER MANUAL
11
3 Operation Instructions And The Camera Adjustment
Camera operation and available options may vary depending on the version of the cam-
era. This manual describes the operation based on the highest available camera configu-
ration.
3.1 Turning the camera on/off and the standby mode
To switch on the camera, press and hold on/off button [12] for around 2 seconds.
A splash screen will be displayed, followed by the self-test procedure of the device. When
the procedure is completed, the camera is ready to be used, and real time infrared image
mode is on.
Short pressing the On / Off button [12] at working camera will turn off the screen and the
camera will switch into a power saving mode (standby mode). A second press of on / off
button [12] will resume the camera to its normal operation.
To switch off the camera completely, press and hold down on/off button [12], until follow-
ing information appears on the screen: (POWER OFF?). The camera will then be
switched off.
Press "OK" to turn off the camera or "Cancel" to cancel the switch off procedure.
3.2 Displaying image on screen/viewfinder
During the camera operation in real time mode the image can be displayed on either the
LCD screen or in the viewfinder. Toggle between these two display modes with
Display/View Finder switch button [1].
3.3 Focus adjustment
Focus can be adjusted in manual or in auto mode. Focus can be adjusted in manual or in
auto mode. In manual mode aim the lens at the target and then move the joystick [18] up
or down. For very precise focus setting move the joystick [18] left or right
– focus will be
adjusted automatically.
Another way to adjust the focus automatically is programming
the ‘C’ (2) button into auto
focus mode (the 'C' button programming process is described in chapter 11.1). Press it
and the camera will focus, provided that the object, which the camera is being set to focus
on, has a large enough thermal contrast. In case the auto focus results are dissatisfying,
use the manual focus mode.
3.4 Enlarging the image
– ZOOM
Image enlargement can be controlled. In order to do so, after aiming the camera on the
measured object, use the zoom button [4]. Press the right side of the button (T) to enlarge
the image (up to x4.0 or x10, depending on the camera model), press the left side of the
