OPERATING MANUAL MMR-630 Revision 1.6
23
Notes:
- What is saved in the memory is the principal result and additional results, as well as the following
information: noise present in the object during the measurement and limitation of the measurement
current or, in the same location, too low a voltage of accumulators during the measurement (this is
priority information).
- In the case the user attempts to save information in an occupied cell the following warning is dis-
played in place of the principal result:
Cell used! Overwrite?
If the button
is pressed, the new re-
sult of the measurement will be saved and the previous one deleted.
- Saving in the memory is signalled by means of the symbol
which is displayed on the screen and
three short sound signals.
- After information is saved in the last cell in the given bank, the following message is displayed:
Last
cell in bank!
4.2
Automatic saving of measurement results in the memory
In
MENU
set the automatic mode of saving results in the memory (see Chapter 3.1.4).
Before the first measurement commences, select the initial cell for saving a series of results in the
memory (see Chapter 3.2): using buttons
and
select the number of the bank and using
buttons
and
select the number of the cell.
Notes:
- Automatic saving of the result of measurement to the memory takes place directly after it has been
displayed and it is realised in accordance with the procedure described in Chapter 4.1.
- In the automatic mode of measurement release after a modification of the number of the bank or
cell, exit the setting mode using the button
or
ESC
, or start the first measurement using the but-
ton
START
.
Summary of Contents for MMR-630
