22
3
Memory of measurement results
MRP-201 meters are equipped with the memory that can store 10000 single measurement
results. The whole memory is divided into 10 memory banks with 99 cells in each bank. Thanks to
dynamic memory allocation, each of the memory cells can contain different quantity of single
measurement results, depending on the needs. Optimal use of the memory can be ensured in this
way. Each measurement result can be stored in a memory cell marked with a selected number and in
a selected memory bank. Thanks to this, the user of the meter can, at his/her option, assign memory
cell numbers to individual measurement points and the memory bank numbers to individual facilities.
The user can also perform measurements in any sequence and repeat them without losing other data.
Memory of measurement results
is not deleted
when the meter is switched off. Thanks to this,
the data can be later read or sent to a computer. The number of a current memory cell or memory
bank is not changed either.
Note:
- Results of measurements performed for all measuring functions can be stored in one memory cell.
- After each entry of the measurement result to the cell, its number is automatically incremented. Set
the appropriate cell number to allow entering to a single cell of successive measurement results
relating to a given measuring point (facility).
- Only the results of measurements triggered by
START
push-button may be stored in the memory.
- It is recommended to delete the memory after reading the data or before performing a new series of
measurements that may be stored into the same memory cells as the previous ones.
3.1 Storing the measurement result data in the memory
Press
ENTER
after completion of
the measurement.
The meter is in the memory
storing mode.
The cell number is
flashing.
Cell is empty.
The cell contains the
result of the same type
which is to be entered.
The cell contains the
measurement results of
the displayed types.
After 5s the first result
displayed.
