6
Attention:
Due to continuous development of the meter
’s software, the actual appearance of the
display, in case of some of the functions, may slightly differ from the display presented in
this operating manual.
2
Measurements
WARNING:
During RCD measurements, the earthed parts and parts accessible in the electrical
installation being tested must not be touched.
WARNING:
During a measurement, switching of the range switch is forbidden because it may damage
the meter and pose a threat to the user.
2.1 Selection of general measurement parameters
Keeping the
SET/SEL
button
depressed, turn on the meter and wait
for the parameter selection screen.
Use the
,
buttons to go to the next
parameter.
Use the
,
buttons to change the parameter
value. The value or symbol to be changed is
flashing.
The
symbol indicates an active parameter,
the
- symbol indicates an inactive one.
Set the parameters according to the following algorithm:
