MRU-200-GPS OPERATING MANUAL Version 1.06
10
Wrap the clamps around the wire referred to in sec.
(up to 4 times).
Use
FLEX
and
TURNS
buttons on ERP-1 adapter to select the clamps
and number of wraps, according to the actual situation around the wire
referred to in sec.
.
Press
START
button on MRU meter.
If the calibration is successful, you will see the following screen.
The meter has determined the correction factor for connected clamp. The factor is saved in the
memory also when the power supply of the meter is off until the following successful calibration of the
clamp has been performed.
