USER MANUAL
Applies for products
●
Double-wire test lead 3 m (16 / 32 A) U1 / I1 –
WAPRZ003DZBBU1I1
●
Double-wire test lead 3 m (16 / 32 A) U2 / I2 –
WAPRZ003DZBBU2I2
General information
●
The product conforms to EN 61010-031 standard.
●
Measurement categories according to EN 61010-2-030:
▪
CAT II – concerns measurements performed in circuits directly connected to low voltage installations,
▪
CAT III – concerns measurements performed in buildings installations,
▪
CAT IV – concerns measurements performed at the source of low voltage installation.
●
The cooperation of the product with the measuring instrument is described in the manual of the dedi-
cated meter.
Technical data
Measurement category acc. to EN 61010-2-030 ............................................ CAT IV 600 V / CAT III 1000 V
Cross section of the blue lead (U1, U2) ...........................................................................................0.75 mm
2
Cross section of the red lead (I1, I2) .................................................................................................2.5 mm
2
Current of the blue lead (U1, U2) ............................................................................................................ 16 A
Current of the red lead (I1, I2)
▪ long-lasting load
.................................................................................................................................... 32 A
▪ maximal load at 30 ms
........................................................................................................................ 350 A
WARNING
Follow the instructions below to avoid electric shocks and other injuries.
●
Do not use the product above maximum ratings.
● If this product is used in a manner not specified by the instructions, the pro
-
tection may be impaired.
● It is forbidden to use the product when it is damaged (sparks, chafing, cuts,
etc.). Damaged test equipment must be replaced with new ones.
● Test leads must be properly connected to the meter and other accessories.
●
In a situation where the product cooperates with other devices, the lowest measuring
category of the connected devices is used.
●
Clean the product with a soft cloth dampened with water and a mild cleaning agent. It
is forbidden to immerse the product in fluids.
