These characteristics are only given as reference. The manufacturer reserves the right to introduce any amendments without prior notice in order to improve the product.
P3270-73 / 15-06-06
TECHNICAL CHARACTERISTICS
INSTALLATION EXAMPLE
INSTALLATION RECOMMENDATIONS
SUPPLY:
Operation: 180-264 V AC / 50-60Hz for
P3270
92-132 VAC / 50-60Hz for
P3273
Maximum power: 60 VA
Voutput: adjusted between 16V ± 5%
Ioutput:: 4 A max.
Electronic protection against short-circuits and overload in the
output.
Internal protection fuse of the power supply unit.
REMOTE IGNITION:
MinimumV in terminal 1: 9 V
LED indicator (green) of activation of remote control.
GENERAL:
Maximum dimensions: : 142 x 146 x 50 mm.
Minimum flush space: 120 x 120 x 40 mm.
Weight: 420 grs.
KM9211-01
(WHITE)
KM9211-02
(CHARCOAL)
KM9211-03
(TWO-TONE)
In
Sonelco’s
General Diagrams, you will find connection diagrams and cable sections recommended for the audio installation.
Do not install this product in damp places, near heat sources or in potentially explosive atmospheres.
The connection to the mains, installation, cable section and wiring will be done in accordance with the directives and specific regulations of each coun-
try.
Sonelco
recommends installing a specific on/off switch for the sound system (See installation example).
Sonelco declines any responsibility which might be derived from the incorrect use of the product or installation not in accordance with that
DOUBLE FRONT FRAME + SUPPLEMENT FOR "SONELCO" BOXES:
During the installation of main units and power supply units, it is advisa-
ble to fit the supplement (3). By doing this an extra 12 mm. bottom is
achieved on the flushmount box (1), which makes assembly easier and
provides greater ventilation.
To correctly assemble the supplement:
-Remove the four screws (5) from the flushmount box (1)
-Pass the wires through the supplement (3)
-Connect and screw the module (4) together with the supplement (3) to
the flushmount box (1)
-Place the frame (2) on the base plate (4) and press
-Place the side screws (7)
-Put the covers (8) on the sides (2)
-Optionally, trims can be fitted (6)
OPERATION INCIDENTS:
Warning:
The power supply unit must only be handled by specialised
technical personnel and with the power switch of the audio system
disconnected.
A.- IF LED 9 (ON) DOES NOT LIGHT UP WHEN THE POWER
SWITCH IS ACTIVATED
1 -
Check that there is voltage, that the mains wires are correctly con-
nected or if fuse (4), (situated under the upper lid) has blown. If this
fuse has blown replace it with another one of the same characteristics
and value.
2 -
Disconnect strip 2, 4. If the led comes on, the power supply unit is
OK, indicating a short circuit in the supply output (2,4) having to check
the wiring.
B.- THE (ON) LED BLINKS ON AND OFF.
1 -
The main unit is on protected mode due to excess load in its supply
terminals. Inspect the wiring of the system and the no. of modules con-
nected to this power supply unit. The maximum power that the unit can
supply may have been exceeded.
AS A CENTRALISED
INSTALLATION
AS AN AUXILIARY
POWER SUPPLY
GENERAL LINE
Max.
4000MA
in total
Max.
4500MA
in total
Main unit
ON/OFF SWITCH
INSTALLATION RECOMMENDATIONS
Por GERARDO fecha 10:02 , 15/06/2006
