1.
The unterminated end of the supplied charging cable assembly and
fuse assembly must be wired to the vehicle per the diagram above.
2.
Observe correct polarity when connecting the charger cable to
12V from the vehicle. Connect the RED wire to +12V and the
BLACK wire to battery chassis ground. This will result in a positive
center terminal of the charger jack as shown in the illustration.
3.
Charge MiniHub completely before use with 12V vehicle
power supply or supplied wall mount charger
.
4.
For maximum battery shelf life, turn OFF the MiniHub.
RED
BLACK
LED Indicators: Charging Depleted Battery
Battery Level Indicator
Number of RED and GREEN Flashes at Turn ON
No Light
(First 20 Minutes of Charging)
Flashing Red
(While Charging)
Steady Green
(Fully Charged)
20 Minutes
0%
100%
2 Hours
P A I R I N G
MiniHub
™
FEATURES
-60
-40
-20
0
20
40
Ba
tt
er
y
Ca
pa
ci
ty
in
H
ou
rs
Degrees Centigrade
Battery Life vs Temperature
14
12
10
8
6
4
2
0
60
80
75%
>
50-75%
25-50%
25%
<
Wall Adapter Charging
Only charge the MiniHub using the supplied 12VDC regulated wall
adapter. Using unregulated wall adapters will damage the Base
Station charging circuit and components and void the warranty.
Vehicle Charging
Note:
Make fuse no further than 18" from the battery.
Note:
Only replace fuse with the same type, 1.5A AGU.
1.5A Fuse
Vehicle Battery
BLACK to Chassis Ground
BATTERY INDICATORS
CHARGING & INSTALLATIONS
Power Button
Pair Button
Green LED Red LED
Charging Jack
RED to
WAR N I N G
To avoid unpairing of existing Headsets, previously paired
Headsets must be ON and connected before pairing a
new Headset.
Headset with
Toggle Switch
Headset with
PTT Button
Power On
Toggle Up
Power On
PTT Button
Up=PTT On
C
W
To pair to the MiniHub; hold PTT button down on the Headset
(on Toggle Headsets; hold toggle switch up) and then turn
power ON. When both Red/Green Headset LEDs are alternating,
release the PTT button (on Toggle Headsets; release toggle
switch). The Headset will connect to MiniHub within 30 seconds.
Up=PTT On
C
When the Headset Green LED remains steadily ON the
headset is successfully paired to the MiniHub. If the Headset
Green LED flashes rapidly then repeat the pairing procedure.
A
B
C
Up=PTT On
C
Paired
Not Paired
Press and hold the pairing button while turning on power to
the MiniHub. After 5 seconds the green and red LEDs will start
flashing in a fast alternating pattern. Release the pairing
button.
