17 |
P a g e
PC Programming
The Wireless Base Station in your ComHub has a USB port located near
the Antenna Jack. Using the Sonetics Configurator program, you can
adjust additional features using a Windows PC, or perform firmware
updates when necessary. Refer to the program for additional
information.
Locating the USB Port
Installation of the Sonetics Configurator Windows
Program
1.
Go to
2.
Download and install the Sonetics Configuration Utility program
to update the firmware on the wireless base station.
3.
Plug in the USB cable from the Wireless Base Station to the
computer. The Base Station will power up.
4.
Open the Sonetics program.
5.
Follow the directions of the Sonetics program.
(
Left
) The USB port is located in the center of the
side wall of the base station, just below the
Sonetics logo.
(
Below
) To access the USB port, remove the tray
from the case by lifting up at the edges to
release the hook-and-loop fasteners.
