11 |
P a g e
Pairing Headsets
Pairing creates a connection between a ComHub Base Station and the
Headset. This is only required once. After pairing, Headsets will connect
automatically. You may pair any Headset to any position on either Base
Station.
Full-Duplex Pairing
1.
Press and hold the desired pairing button until its link indicator begins
to flash slowly. Any previous pairing will be forgotten.
2.
With headset powered OFF, place the Headset into pairing mode by
pressing the right PTT button and the power button until you hear
"base station registering".
3.
The Base Station will automatically connect, showing a solid link LED.
4.
If the pairing was unsuccessful, repeat Steps 1-4 above.
5.
Pair any additional Wireless Headsets to remaining open positions.
Broadcast Mode Pairing
Broadcast Mode allows 100 devices to be paired. A full duplex pairing
must be present to activate Broadcast Mode. Broadcast users cannot
Radio Transmit. NOTE: Users may experience a slight loss of range when
utilizing Broadcast Mode.
Example:
Position 1 has a Full Duplex Headset pairing. Positions 2-4 are
available for devices to share. Position 5 broadcasts back to the group.
1.
Press and hold Buttons 4 & 5 until their link LEDs flash slowly.
2.
Place the wireless device you wish to link into pairing mode (see Step
2 above).
3.
The Wireless Base Station will automatically connect showing a solid
link LED on Position 5 and the device will show connected (refer to
the Sonetics device manual).
