15 |
P a g e
DECT CHANNEL MODE OPERATION
When used in this configuration, up to 5 channels are available from
only one of the ComHub’s two Base Stations.
Configuring for Channel Selection (ComHub Mode)
To enter configuration mode; select a Base Station on which to enable
DECT channels.
NOTE
: Either Base Station will work for this purpose. In
order to use DECT channels, Wireless Headset users must be paired to
the Base Station with DECT channels enabled.
1.
Power off the ComHub.
2.
While holding the Position 3 pairing button, power on the
ComHub.
3.
Continue holding the Position 3 pairing button for 10 seconds.
4.
The Base Station is now ready to select the number of DECT
channels.
Selecting the Number of Available Channels
5.
Press the pair button corresponding to the number of channels
desired (button 2 = 2 channels, etc.).
6.
To exit configuration mode, power off the ComHub and then
power it on.
Headset Verification of Available DECT Channels
Before you begin using channels, verify that you have the expected
number of available DECT channels by cycling through channels using
the Wireless Headset:
1.
Turn on your APX377 or APX379 Wireless Headset.
2.
Allow the Headset to pair with the ComHub or Base Station.
3.
Press the forward
and back
buttons together to toggle
DECT Channel Selection. A voice prompt announces “Channel”.
4.
Press the forward
or back
button on the right-hand side of
the Headset. Voice prompts announce “Channel 1”, “Channel
2”, and so on.
5.
If you are unable to access the expected number of DECT
channels, repeat Steps 1-6 in “Configuring and Selecting…”
above.
