9 |
P a g e
Modular Plug Installation
1.
Using the cutter blade on the crimping tool (
A)
, cut the flat CA Cable so the
cut is clean and 90 degrees to the sides of the cable.
2.
Insert one end of the CA Cable between the stripping blades (
C
) until the
end of the cable hits the stop (
B
).
3.
Squeeze the handles of the crimping tool together until the tool bottoms
out.
4.
While holding the handles together, pull the cable out of the tool.
5.
The stripped insulation should expose approximately 3/16” of wire.
6.
Push a RJ Modular Plug into the plug holder on the crimping tool (
D
) until
the release tab on the plug locks into position.
7.
Holding the cable so that the printed side (or smooth side) of the cable is
toward the release-tab on the plug, push the cable into the plug as far as it
will go.
ALWAYS make sure the printed side (or smooth side) of
the cable is facing the release-tab on the RJ Modular Plug.
8.
Squeeze the tool handles
COMPLETELY
together. You may feel the crimper
finish punching the contacts through the insulation on the wires.
9.
Let the handles spring open.
10.
Push down on the release-tab on the RJ Modular Plug and remove the RJ
Modular Plug from the crimping tool.
11.
Inspect the plug to ensure that the cable is held securely in place.
Summary of Contents for SON150
