13 |
P a g e
Use with a Legacy Intercom
(30XXR, 110, and 210 Intercoms)
The Wireless Base Station is designed to integrate into older Legacy Sonetics
Intercom systems. This lets the user operate two-way-radios with a Wireless
Headset. When used in Legacy Intercom mode, the Wireless Base Station must
have Ports 1 and 6 connected to the Sonetics Intercom. This allows Intercom
Only Headsets to hear the communications of a Headset utilizing radio transmit.
Only one channel is available in Legacy Intercom Mode.
Setting up Legacy Intercom Mode
1.
Unplug the Base Station, then plug it back in while holding the Pairing
buttons for positions 2 and 3 until the green channel indicator LEDs for
positions 2 and 3 light up (about 5 seconds).
2.
The Base Station is now in Legacy Intercom mode.
3.
Unplug the Base Station, then plug it back in. The Base Station is now ready
to use. In this mode, the position a Headset is paired to does not impact its
operation.
Intercom Connections
1.
In this mode port 6 must be connected to a Sonetics Intercom using the
supplied flat cable.
2.
Pair the Headset(s) to the Base Station. For Radio Transmit operation, make
sure your Headset is a radio transmit model and that it is configured to
transmit radio over DECT. Consult your Headset manual for instructions.
If Radio Transmit operation is required, connect port 1 to the Sonetics
Intercom using the correct type flat cable. The Sonetics Intercom must be
connected to a two-way-radio.
Operation
All non-radio transmit audio is through Port 6 of the Base Station. When a Radio
Transmit Headset initiates a transmission by activating its PTT button, its audio
is switched to Port 1 along with the PTT signal.
Summary of Contents for SON150
