Ⅲ
-IV-19
4-6
Assigning J51 connector pins
The model SR-87 transducer comes with a J51 connector which outputs ES
data to an external device (signal output for a remote ES).
Table 4-20 J51 pin assignment table
Pin No Signal name
Format
Signal level
1
TRG_OUT
Trigger output
0-5V negative polarity
2
DGND
3
FF_L
ES output
(No.1)
5 VAC output (when a 38, 70, or 120 kHz
ES is installed)
12 VAC output (when another ES is
installed)
4
AGND
5
FF_H
ES output
(No.2)
No output (when 38, 70, or 120 kHz is
installed)
12 VAC output (when another ES is
installed)
6
AGND
4-6-1
ES signal output setting
Set the ES signal to be output to an external device (signal output for a
remote ES) from the model SR-87 transducer.
(1) Setting the ETR board
When a 38, 70, or 120 kHz ES is installed, set SW2 on the ETR-10
board inside the model SR-87 transducer to OFF. (See Fig. 4-15.)
The factory setting is OFF.
Fig. 4-15
ETR-10 board silk screen drawing and SW2
Note that in the case where an ES is installed, there are no changes
in the board settings.
Summary of Contents for KSE-310
